1999 - 2010 SV650 / SV1000 HID BiXenon Projector headlight kit with angel eyes halo

Compatible with 1999 - 2010 SV650 naked Stock 7" Inch round headlight

This is a direct bolt on kit, no major modifications required!

Each projector kit will include everything that you need and will consist of the following:

1 Mini bixenon projector (low beam and high beam)
1 slim water proof ballast
1 35w hid bulb in 4300K (pure white) OR 6000K (blueish white) OR 8000K(blue)
1 complete motorcycle harness, including an H4 plug, so no need to cut off your OEM plug. This kit is pretty much plug and play.
1 halo/angel eye inverter
1 White Halo/angel eye (Blue available $10 extra)

 

Proffesional installation available, You can mail us your headlight and we will install this projector kit and return it assembled and plug and play.

Contact us for a quote sales@bkmoto.com

General installation instructions:

1. Remove headlight from bike
2. remove bucket from headlight, remove bezel from headlight
3. bake headlight in the oven for 5-8 minutes at 200 degrees,(put a moist towel under headlight so it doesnt melt to the pan!); once the glue softens up, use flat head screw drivers to remove lens from headlight; you might need to repeat this a few times untill the lens is off. ( be gentle and work your way around the headlight, open it up little by little all around ).
4. Drill a hole for the halo and hi/low beam controller wires from the back (look at my picture for referance)
5. cut controller and halo wires, fish them though hole, then put wires back together.
6. Insert H4 adapter plate from the back
7. drill 3 tiny holes through the holes of the adapter plate and secure the plate with the tiny screws (screws are included)
8. remove hid bulb from projector and remove the nut
9. Insert projector into the adapter plate, and slightly tighten the nut.
10. Now you need to level the projector; install the open headlight on the bike, connect the harness to battery positive, and any bolt on the frame for ground,
11. Plug the ballast into hib bulb and harness, plug in the H4 plug into the bike; level the bike and turn on the headlight. you need to shine the light on a flat wall.
12. Turn the projector untill the light cutoff is completely horizontal.
13. once projector is leveled, tighten rear nut. (USE LOCKTITE!!!)
14. remove headlight from bike
15. clean headlight and lens from fingerprints and dust
16. put back in oven at 200 degrees for 5 minutes
17. put the lens back on, and continue assembling headlight
18. put headlight back onto the bike and continue onto the wiring.
19. locate a good spot for the ballast and wiring. I recommend to lift the gas tank, and stuff everything infront of the airbox next to the intake snorkle, then use the frame openings in the front to run all wires to the headlight.
20. wire it up nice and neat and enjoy you new headlight!
 

Write a review